In many situations, it is either not possible to gain access to a cable for making an electrical contact or it is not safe to do so. The SC-600 Signal Clamp accessory provides an efficient and safe method of applying a locate signal to a cable, enabling the UAT-600 Transmitter to induce a signal through the insulation into the wires or pipes. The clamp works on low impedance closed circuits only.
The SC-600 is included with the UAT-620 Underground Utilities Locator kit.
| Features | SC-600 Signal Clamp |
| Measurement category | CAT IV 600 V |
| Operating voltage/current | 0 to 600 V, 100 A max. |
| Operating frequency/tracing modes | 33 kHz and 8 kHz |
| Signal voltage output (nominal) | 23 V rms at 8 kHz 30 V rms at 33 kHz |
| Operating temperature and humidity | -4 °F to 122 °F (-20 °C to 50 °C), ≤90% RH |
| Storage temperature and humidity | -40 °F to 140 °F (-40 °C to 60 °C), ≤90% RH |
| Operating altitude | < 6561 ft (< 2000 m) |
| Pollution degree | 2 |
| Water and dust resistance | IP54 |
| Drop proof | 3.28 ft (1 m) |
| Agency approval |   |
| Safety compliance | IEC 61010-1, IEC 61010-2-033 CSA/UL 61010-1, CSA/UL 61010-2-033 |
| Size (H x W x L) | Approx. 11.6 x 7.1 x 1.4 in (295 x 180 x 37 mm) |
| Weight | Approx. 1.9 lb (0.85 kg) |
UAT-600 Series Overview
Accurately and safely pinpoint underground utilities before you dig.
| Application Note » |
| Datasheet » |
| Datasheet – French » |
| Datasheet – Portuguese » |
| Datasheet – Spanish » |
| Quick Start Guide » |
| Product Manual » |
Reviews
There are no reviews yet.